|
● Rated power: 2kW, 3kW, 4kW, 5kW, 6kW, 12kW, 18kW, 24kW (with parallel function, up to 240kw)
|
● Real-time power supply load transient response simulation and voltage peak value (Vpk/-) measurement
|
|
● Voltage range 0-150V, 0-600V, 0-1200V
|
● 255 sets of timing high-precision voltage and current measurements can be programmed directly from the front panel
|
|
● The current range is up to 2000A
|
● High-speed and accurate digitizing data/measurement capture
|
|
● Low Voltage Operation Characteristics 0.6V@1000A (Typical).
|
● When the DUT is protected from overcurrent/overload, the voltage, current, and protection point of the maximum power point (Pmax) are measured
|
|
● Constant current, constant resistance, constant voltage and constant power operation modes
|
●Time measurement, battery discharge timing
|
|
● Constant resistance, constant current, constant resistance, constant voltage, constant current
|
● Instantaneous overpower pulling
|
|
● Advanced operation modes such as constant voltage
|
● Short circuit simulation
|
|
● Master/slave parallel control, the number of parallel connections is up to 10 units
|
● Intelligent fan control
|
|
● Synchronous dynamic control under static and dynamic loads
|
● Protection function over current (adjustable), over temperature, over power (adjustable)
|
|
● User Defined Waveform (UDW)
|
● Protection and overvoltage, reverse alarms
|
|
● Constant Impedance (CZ) mode simulates capacitive load power-on
|
● USB interface is standard
|
|
● External load current simulation
|
● Optional Ethernet, GPIB, CANBUS interfaces
|
|
● Up to 50kHz Automatic Variable Frequency Dynamic Sweep
|
|
